How to set ip manually in backtrack 5

 · Backtrack 5 R3 is one of the Linux operating system so we can operate. Backtrack with Linux common comman d. Setting your IP manually. Author: Ameer Sameer. When manually setting the IP address, you will also have to manually set the gateway of your network connection to your router. Something like: # route add default gw The actual IP address of the router is network dependent (but for private networks like yours, it is often.1). 1. Edit /etc/network/interfaces file #rootbt: nano /etc/network/interfaces 2. Change the default example to these lines auto eth0 iface eth0 inet static address network netmask broadcast gateway 3. Save edited file by pressing Ctrl+O 4. Restart Network just to make it sure it works.

Set a Static IP Address in Windows XP. To set a Static IP in Windows XP, right-click the "My Network Places" icon, and then select "Properties.". Right-click the adapter for which you want to set the IP, and then select "Properties" from the context menu. Select the "Internet Protocol (TCP/IP)" entry, and then click the. Setting Up the LAN Connection 1 Connect the LAN cable. The IP address will be automatically confi gured in 2 minutes. If you want to set the IP address manually, see the following items. User's Guide "Setting IP Addresses" 2 Install the drivers on your computer using the provided CD-ROM/DVD-ROM. See "Installing the software" (P.9). NOTE. Select Internet Protocol Version 4 (TCP/IPv4). Click Properties. Select Use the following IP address. Enter the IP address, Subnet mask, Default gateway, and DNS server. Click OK. Your computer displays a static IP address. To set a static IP address on a Macintosh OS X computer, see Configuring TCP/IP and Proxy Settings on Mac OSX.

My partner and I both have difficulties figuring out how to configure static IP in Backtrack 3 in a VMware. He installed Backtrack 3 in a VMware workstation in Windows Vista. I installed Backtrack 3 in a VMware Server in Ubuntu. We tried to follow slackware's documents on static IP configuration. So far no luck. Could anyone shed some light here?. Step 1 – Surveillance. Before we get going with the actual penetration testing, we want to install a free program called “HTTrack” via the Backtrack 5 console. To do this, open Backtrack 5 and enter “sudo apt=get install httrack” and get ready for the next step. Once that’s done, go ahead and type in “httrack” into the console. Using ip and netplan. You should start learning ip now, since it’s about to become common everywhere. Since ifconfig is being phased out, it’s time to get used to the new system. By default, Ubuntu doesn’t use ifconfig anymore, and instead uses the new commands, ip and netplan. Show your IP using ip. ip addr show. Bring an interface.